beautypg.com

Front panel function overview, Vertical, Front panel function overview -16 – RIGOL DS6000 Series User Manual

Page 38: Vertical -16

background image

RIGOL

1 Quick Start

DS6000 User’s Guide

1-16

Front Panel Function Overview

VERTICAL

CH1, CH2, CH3, CH4: analog input

channels. The four channels are marked
by different colors which are also used to
mark both the waveforms on the screen
and the channel input connectors. Press
any key to turn on the corresponding
channel menu and press again to turn
off the channel.
AC: illuminated when AC channel
coupling mode is enabled.
50: illuminated when the channel input
impedance is 50Ω.
BW: illuminated when the bandwidth
limit is turned on.

ALL OFF: press this key to turn off all

the channels that have been turned on.

MATH: press this key to turn on the math operation and decoding function menus

under which to perform add, subtract, multiply, divide, FFT, logic and advanced
operations as well as parallel, RS232, SPI, I2C, CAN and FlexRay decodings.

REF: press this key to turn on the reference waveform function to compare the

waveform actually tested with the reference waveform to decide circuit failures.

VERTICAL POSITION: modify the vertical position of the current channel
waveform. Turn clockwise to increase the position and turn counterclockwise to
decrease. During the modification, the waveform would move up and down and the

position message (e.g.

) at the lower-left corner of the screen

would change accordingly. Press down this knob to quickly reset the vertical position
to zero.