RIGOL DS6000 Series - Manual (Page 252)

RIGOL 13 System Function Setting
DS6000 User’s Guide 13-20
PictBridge Print
After selecting the “PictBridge” print mode, please refer to the following steps to set
the print parameters and execute print.
1. Status
A prompting frame will appear to show the current print status after you press
this softkey.
2. Print Range
Press this softkey to select “Screen” (default) or “Wave”.
 Screen: print the whole screen image.
 Wave: only print the waveform and the basic information.
3. Palette
Press this softkey to select “Grayscale” or “Color” (default).
4. Preview
Press this softkey to turn on the preview interface.
5. Size
Press this softkey to select the size of the paper of the print. You can select
default, A2, A3, A4, A5, A6 or B5.
6. Type
Press this softkey to select the picture type of the print. You can select default,
Jpeg or Bmp.
Note: the selection is unavailable when the printer does not support this
function.
PictBridge is a new print standard. If your
oscilloscope and the printer both comply with the
PictBridge standard, you can connect the
oscilloscope to the printer using a USB cable to print
the screen image directly.
Devices complies with the PictBridge standard
always have the icon as shown in the figure on the
right.