RIGOL DS6000 Series - Manual (Page 187)

9 Pass/Fail Test RIGOL
DS6000 User’s Guide 9-1
9 Pass/Fail Test
Monitor the change of the signal by judging whether the input signal is within the
mask created. The test result can be displayed on the screen as well as be prompted
by the system sound or the pulse signal output from the [Trig Out/Calibration]
connector at the rear panel.
The contents of this chapter:
 To Enable Pass/Fail Test Function
 To Select Source
 Mask Range
 Test and Output
 To Save the Test Mask
 To Load the Test Mask