HEIDENHAIN TNC 410 ISO Programming - Manual (Page 99)

HEIDENHAIN TNC 410, TNC 426, TNC 430 73
4.6 Cr
eating
and
W
riting
Pr
ogr
ams
Creating a new part program TNC 410
You always enter a part program in the Programming and Editing
mode of operation:
Select the Programming and Editing mode of
operation.
To call the file manager, press the PGM MGT key.
Select the directory in which you wish to store the new program:
Enter the new program name and confirm your entry
with the ENT key.
Select the file type, e.g. ISO program: Press the .I soft
key.
If necessary, switch to inches as unit of measure:
Press the MM/INCH soft key.
Confirm your entry with the ENT key.
File name = OLD.H