HEIDENHAIN TNC 410 ISO Programming - Manual (Page 434)

408 12 MOD Functions
12.1
0
Sho
w
ing
t
h
e W
o
rk
pie
c
e in
the W
o
rk
in
g Spa
c
e (no
t T
N
C
4
1
0)
12.10 Showing the Workpiece in the
Working Space (not TNC 410)
Function
This MOD function enables you to graphically check the position of the
workpiece blank in the machine's working space and to activate work
space monitoring in the Test Run mode of operation. This function is
activated with the BLANK IN WORK SPACE soft key.
The TNC displays a cuboid for the working space. Its dimensions are
shown in the “Traverse range” window. The TNC takes the
dimensions for the working space from the machine parameters for
the active traverse range. Since the traverse range is defined in the
reference system of the machine, the datum of the cuboid is also the
machine datum. You can see the position of the machine datum in the
cuboid by pressing the soft key M91 in the 2nd soft-key row.
Another cuboid represents the blank form. The TNC takes its
dimensions from the workpiece blank definition in the selected
program. The workpiece cuboid defines the coordinate system for
input. Its datum lies within the cuboid. You can see in the cuboid the
position of the datum for input by pressing the corresponding soft key
in the 2nd soft-key row.
For a test run it normally does not matter where the workpiece blank
is located within the working space. However, if you test programs
that contain movements with M91 or M92, you must graphically shift
the workpiece blank to prevent contour damage. Use the soft keys
shown in the table at right.
You can also activate the working-space monitor for the Test Run
mode in order to test the program with the current datum and the
active traverse ranges (see table below, last line).
Function Soft key
Move workpiece blank to the left
Move workpiece blank to the right
Move workpiece blank forward
Move workpiece blank backward