HEIDENHAIN TNC 410 ISO Programming - Manual (Page 33)

HEIDENHAIN TNC 410, TNC 426, TNC 430 7
1
.3 Mo
des o
f Oper
atio
n Programming and editing
In this mode of operation you can write your part
programs. The various cycles and Q-parameter
functions help you with programming and add
necessary information.
Soft keys for selecting the screen layout (only
TNC 410)
Test Run
In the Test Run mode of operation, the TNC checks
programs and program sections for errors, such as
geometrical incompatibilities, missing or incorrect
data within the program or violations of the work
space. This simulation is supported graphically in
different display modes.
Soft keys for selecting the screen layout: see
“Program Run, Full Sequence and Program Run,
Single Block,” page 8.
Screen windows Soft key
Program
Left: program. Right: help graphics
for cycle programming
Left: program. Right: programming
graphics
Interactive Programming graphics