HEIDENHAIN TNC 410 ISO Programming - Manual (Page 461)

HEIDENHAIN TNC 410, TNC 426, TNC 430 435
13.1 Gener
a
l User P
a
ra
met
e
rs
Operation of various miscellaneous
functions M
Note:
The k
V
factors for position loop gain are set by
the machine tool builder. Refer to your machine
manual.
MP7440
Program stop with M06: +0
No program stop with M06: +1
No cycle call with M89: +0
Cycle call with M89: +2
Program stop with M functions: +0
No program stop with M functions: +4
k
V
factors cannot be switched through M105 and M106: +0 (not TNC 410)
k
V
factors can be switched through M105 and M106: +8 (not TNC 410)
Reduce the feed rate in the tool axis with M103 F..
Function inactive: +0
Reduce the feed rate in the tool axis with M103 F..
Function active: +16
Exact stop for positioning with rotary axes
not active: +0 (not TNC 410)
Exact stop for positioning with rotary axes
active: +32 (not TNC 410)
Error message during cycle call (not TNC 410) MP7441
Error message when M3/M4 not active: 0
Suppress error message when M3/M4 not active: +1
Reserved: +2
Suppress error message when positive depth programmed: +0
Output error message when negative depth programmed: +4
M function for spindle orientation in the fixed
cycles MP7442
Function inactive: 0
Orientation directly through the NC: -1
M function for orienting the spindle: 1 to 999
Maximum contouring speed at feed rate
override setting of 100% in the Program Run
modes MP7470
0 to 99 999 [mm/min]
Feed rate for rotary-axis compensation
movements (not TNC 410) MP7471
0 to 99 999 [mm/min]
Datums from a datum table are referenced to
the MP7475
Workpiece datum: 0
Machine datum: 1
Running pallet tables (not TNC 410) MP7683
Program Run, Single Block: Run one line of the active NC program at every
NC start; Program Run, Full Sequence: Run the entire NC program at every
NC start: +0
Program Run, Single Block: Run the entire NC program at every NC start:+1
Program Run, Full Sequence: Run all NC programs up to the next pallet at
every NC start: +2
Program Run, Full Sequence: Run the entire NC pallet file at every NC
start:+4
Program Run, Full Sequence: If running of the complete pallet file is
selected (+4), then run the pallet file without interruption, i.e. until you
press NC stop: +8
Machining and program run