HEIDENHAIN TNC 410 ISO Programming - Manual (Page 457)

HEIDENHAIN TNC 410, TNC 426, TNC 430 431
13.1 Gener
a
l User P
a
ra
met
e
rs
Configure tool table (to
omit from table, enter
0); Column number in
the tool table MP7266.27
PLC value – PLC-VAL: 0 to 31; column width: 11 characters
MP7266.28
Center misalignment in reference axis – CAL-OFF1: 0 to 31; column width: 11 characters
MP7266.29
Center misalignment in minor axis – CAL-OFF2: 0 to 31; column width: 11 characters
MP7266.30
Spindle angle for calibration – CALL-ANG: 0 to 31; column width: 11 characters
Configure pocket
tables; Column
number in the tool
table
(To omit from the
table: enter 0) MP7267.0
Tool number – T: 0 to 7
MP7267.1
Special tool – ST: 0 to 7
MP7267.2
Fixed pocket – F: 0 to 7
MP7267.3
Pocket locked – L: 0 to 7
MP7267.4
PLC status – PLC: 0 to 7
MP7267.5
Tool name from tool table – TNAME: 0 to 7
MP7267.6
Comment from tool table – DOC: 0 to 7
Manual Operation
mode: Display of feed
rate MP7270
Display feed rate F only if an axis direction button is pressed: 0
Display feed rate F even if no axis direction button is pressed (feed rate defined via soft key F or
feed rate of the “slowest” axis): 1
Decimal character MP7280
The decimal character is a comma: 0
The decimal character is a point: 1
Display mode (not TNC
410) MP7281.0 Programming and Editing operating mode
MP7281.1 Program Run operating modes
Always display multiple line blocks completely: 0
Display multiline blocks completely if the multiline block is the active block: 1
Display multiline blocks completely if the multiline block is being edited: 2
Position display in the
tool axis MP7285
Display is referenced to the tool datum: 0
Display in the tool axis is referenced to the
tool face: 1
Display step for the
spindle position (not
TNC 410) MP7289
0.1 °: 0
0.05 °: 1
0.01 °: 2
0.005 °: 3
0.001 °: 4
0.0005 °: 5
0.0001 °: 6
TNC displays, TNC editor