HEIDENHAIN TNC 410 ISO Programming - Manual (Page 323)

HEIDENHAIN TNC 410, TNC 426, TNC 430 297
8.9 Coo
rdi
nat
e
T
rans
for
m
a
ti
on Cy
cle
s
Editing a datum table with the TNC 410
Select the datum table in the Programming and Editing mode of
operation.
U U U U To call the file manager, press the PGM MGT key, see
“File Management: Fundamentals,” page 43.
U U U U To select an already existing datum table, move the
highlight to the desired table and confirm with the
ENT key
U U U U To open a new datum table, enter a new file name and
confirm with the ENT key. Press the “.D” soft key to
open the table.
Editing a datum table with TNC 426, TNC 430
Select the datum table in the Programming and Editing mode of
operation.
U U U U To call the file manager, press the PGM MGT key; see
“File Management: Fundamentals,” page 43.
U U U U Display the datum tables: Press the soft keys SELECT
TYPE and SHOW .D.
U U U U Select the desired table or enter a new file name.
U U U U Edit the file. The soft-key row comprises the following
functions for editing:
Function Soft key
Select beginning of table
Select end of table
Go to previous page
Go to next page
Insert line (only possible at end of table)
Delete line
Confirm the entered line and go to the beginning of the
next line (not TNC 410)
Add the entered number of lines (reference points) to
the end of the table
Move the highlight one column to the left (not TNC 410)
Move the highlight one column tothe right (not TNC 410)