HEIDENHAIN TNC 410 ISO Programming - Manual (Page 107)

HEIDENHAIN TNC 410, TNC 426, TNC 430 81
4.6 Cr
eating
and
W
riting
Pr
ogr
ams
Editing a program with TNC 410
While you are creating or editing a part program, you can select any
desired line in the program or individual words in a block with the
arrow keys or the soft keys. When you are entering a new block the
TNC identifies the block with a * as long as the block has not been
saved.
Function Soft key/key
Go to previous page
Go to next page
Go to beginning of program
Go to end of program
Move from one block to the next
Select individual words in a block
Function Key
Set the selected word to zero
Erase an incorrect number
Clear a (non-blinking) error message
Delete the selected word
In a block: Restore previously saved version
Delete the selected block
Erase cycles and program sections: First
select the last block of the cycle or program
section to be erased, then erase with the DEL
key.