HEIDENHAIN TNC 410 ISO Programming - Manual (Page 214)

188 8 Programming: Cycles
8.3 Cy
cles f
o
r Dr
illing
, T
a
p
p
ing
and
Th
read Millin
g U U U U Set-up clearance Q200 (incremental value): Distance
between tool tip and workpiece surface.
U U U U Depth Q201 (incremental value): Distance between
workpiece surface and bottom of hole.
U U U U Feed rate for plunging Q206: Traversing speed of
the tool during reaming in mm/min.
U U U U Dwell time at depth Q211: Time in seconds that the
tool remains at the hole bottom.
U U U U Retraction feed rate Q208: Traversing speed of the
tool in mm/min when retracting from the hole. If you
enter Q208 = 0, the tool retracts at the reaming feed
rate.
U U U U Workpiece surface coordinate Q203 (absolute
value): Coordinate of the workpiece surface.
U U U U 2nd set-up clearance Q204 (incremental value):
Coordinate in the tool axis at which no collision
between tool and workpiece (clamping devices) can
occur.
Example: NC block
N80 G201 Q200=2 Q201=-20 Q206=150
Q211=0.25 Q208=30000 Q203=+0 Q204=50 *