8 adding comments, Function, Adding comments during program input (not tnc 410) – HEIDENHAIN TNC 410 ISO Programming User Manual
Page 111: Adding comments after program input (not tnc 410), Entering a comment in a separate block, 8 a d din g co mmen ts 4.8 adding comments
HEIDENHAIN TNC 410, TNC 426, TNC 430
85
4.8 A
d
din
g
Co
mmen
ts
4.8 Adding Comments
Function
You can add comments to any desired block in the
part program to explain program steps or make
general notes. There are three possibilities to add
comments:
Adding comments during program
input (not TNC 410)
U
U
U
U
Enter the data for a program block, then press the
semicolon key “;” on the alphabetic keyboard—
the TNC displays the dialog prompt COMMENT ?
U
U
U
U
Enter your comment and conclude the block by
pressing the END key.
Adding comments after program input
(not TNC 410)
U
U
U
U
Select the block to which a comment is to be
added.
U
U
U
U
Select the last word in the block with the right
arrow key: A semicolon appears at the end of the
block and the TNC displays the dialog prompt
COMMENT ?
U
U
U
U
Enter your comment and conclude the block by
pressing the END key.
Entering a comment in a separate block
U
U
U
U
Select the block after which the comment is to be
inserted.
U
U
U
U
Initiate the programming dialog with the
semicolon key “;” on the alphabetic keyboard.
U
U
U
U
Enter your comment and conclude the block by
pressing the END key.