HEIDENHAIN TNC 410 ISO Programming - Manual (Page 392)

366 11 Test Run and Program Run
1
1
.1 Gr
aph
ics
Projection in 3 planes
Similar to a workpiece drawing, the part is displayed
with a plan view and two sectional planes. A symbol
to the lower left indicates whether the display is in
first angle or third angle projection according to ISO
6433 (selected with MP7310).
Details can be isolated in this display mode for
magnification (not TNC 410, see “Magnifying
details,” page 367.
In addition, you can shift the sectional planes with
the corresponding soft keys:
U U U U Press the soft key for projection in
three planes.
U U U U Shift the soft-key row until the TNC
displays the following soft keys:
The positions of the sectional planes are visible
during shifting.
Coordinates of the line of intersection
(not TNC 410)
At the bottom of the graphics window, the TNC
displays the coordinates of the line of intersection,
referenced to the workpiece datum. Only the
coordinates of the working plane are shown. This
function is activated with Machine Parameter 7310.
Function Soft keys
Shift the vertical sectional
plane to the right or left
Shift the horizontal
sectional plane upwards
or downwards