2 t o ol d a ta – HEIDENHAIN TNC 410 ISO Programming User Manual
Page 129
HEIDENHAIN TNC 410, TNC 426, TNC 430
103
5.2 T
o
ol D
a
ta
Tool table: Tool data for 3-D touch trigger probe (only when bit 1
is set in MP7411 = 1, see also the Touch Probe Cycles Manual)
Abbr.
Input
Dialog
CAL-OF1
During calibration, the TNC stores in this column the center
misalignment in the reference axis of the 3-D probe, if a tool number
is indicated in the calibration menu.
Center misalignmt. in ref. axis?
CAL-OF2
During calibration, the TNC stores in this column the center
misalignment in the minor axis of the 3-D probe, if a tool number is
indicated in the calibration menu.
Center misalignment minor axis?
CAL-ANG
During calibration, the TNC stores in this column the spindle angle at
which the 3-D probe was calibrated, if a tool number is indicated in
the calibration menu.
Spindle angle for calibration?