HEIDENHAIN TNC 410 ISO Programming - Manual (Page 105)

HEIDENHAIN TNC 410, TNC 426, TNC 430 79
4.6 Cr
eating
and
W
riting
Pr
ogr
ams
Marking, copying, deleting and inserting program sections
The TNC provides certain functions (listed in table below) for copying
program sections within an NC program or into another NC program.
To copy a program section, proceed as follows:
U U U U Select the soft-key row using the marking function.
U U U U Select the first (last) block of the section you wish to copy.
U U U U To mark the first (last) block: Press the SELECT BLOCK soft key. The
TNC then highlights the first character of the block and
superimposes the soft key CANCEL SELECTION.
U U U U Move the highlight to the last (first) block of the program section you
wish to copy or delete. The TNC shows the marked blocks in a
different color. You can end the marking function at any time by
pressing the CANCEL SELECTION soft key.
U U U U To copy the selected program section: Press the COPY BLOCK soft
key, and to delete the selected section: Press the DELETE BLOCK
soft key. The TNC stores the selected block.
U U U U Using the arrow keys, select the block after which you wish to insert
the copied (deleted) program section.
U U U U To insert the block: Press the INSERT BLOCK soft key.
To insert the section into another program, select the
corresponding program using the File Manager and then
mark the block after which you wish to insert the copied
block.
Function Soft key
Switch on marking function
Switch off marking function
Delete marked block
Insert block that is stored in the buffer memory
Copy marked block