HEIDENHAIN TNC 410 ISO Programming - Manual (Page 393)

HEIDENHAIN TNC 410, TNC 426, TNC 430 367
1
1
.1 Gr
aph
ics
3-D view
The workpiece is displayed in three dimensions, and
can be rotated about the vertical axis.
In 3-D view, the workpiece can be rotated about the
vertical axis. The shape of the workpiece blank can
be depicted by a frame overlay at the beginning of
the graphic simulation (not TNC 410).
In the Test Run mode of operation you can isolate
details for magnification, see “Magnifying details,”
page 367.
U U U U Press the soft key for 3-D view.
To rotate the 3-D view
Shift the soft-key row until the following soft keys
appear:
Switch the frame overlay display for the
workpiece blank on/off (not TNC 410):
U U U U Show the frame overlay with
SHOW BLK FORM.
U U U U Omit the frame overlay with OMIT
BLK-FORM
Magnifying details
You can magnify details in the Test Run mode of
operation in the following display modes, provided
that the graphic simulation is stopped:
n
Projection in three planes
n 3-D view
The graphic simulation must first have been
stopped. A detail magnification is always effective in
all display modes.
Function Soft keys
Rotate the workpiece in
27° steps about the
vertical axis