HEIDENHAIN TNC 410 ISO Programming - Manual (Page 399)

HEIDENHAIN TNC 410, TNC 426, TNC 430 373
1
1
.3 T
e
st
Ru
n Run a program test up to a certain block
With the STOP AT N function the TNC does a test
run up to the block with block number N.
U U U U Go to the beginning of program in the Test Run
mode of operation.
U U U U To run a program test up to a specific block,
press the STOP AT N soft key.
U U U U Stop at N: Enter the block number
at which you wish the test to stop.
U U U U Program: Enter the name of the
program that contains the block
with the selected block number.
The TNC displays the name of the
selected program. If the test run is
to be interrupted in a program that
was called with %, you must enter
this name.
U U U U Repetitions: If N is located in a
program section repeat, enter the
number of repeats that you want to
run.
U U U U To test a program section, press the
START soft key. The TNC will test
the program up to the entered
block.