7 optional block skip, Function, 7 option al blo c k skip 11.7 optional block skip – HEIDENHAIN TNC 410 ISO Programming User Manual
Page 411
HEIDENHAIN TNC 410, TNC 426, TNC 430
385
1
1
.7 Option
al blo
c
k skip
11.7 Optional block skip
Function
In a test run or program run, the TNC can skip over blocks that begin
with a slash “/”:
U
U
U
U
To run or test the program without the blocks
preceded by a slash, set the soft key to ON.
U
U
U
U
To run or test the program with the blocks preceded
by a slash, set the soft key to OFF.
This function does not work for G99 blocks.
After a power interruption the TNC returns to the most
recently selected setting.
This manual is related to the following products: