HEIDENHAIN TNC 410 ISO Programming - Manual (Page 347)

HEIDENHAIN TNC 410, TNC 426, TNC 430 321
9.5 Nestin
g Program execution
1 Main program UPGMS is executed up to block N170.
2 Subprogram 1 is called, and executed up to block N390.
3 Subprogram 2 is called, and executed up to block N620. End of
subprogram 2 and return jump to the subprogram from which it
was called.
4 Subprogram 1 is executed from block N400 up to block N450. End
of subprogram 1 and return jump to the main program SUBPGMS.
5 Main program UPGMS is executed from block N180 up to block
N350. Return jump to block 1 and end of program.
Repeating program section repeats
Example NC blocks
Program execution
1 Main program REPS is executed up to block N270.
2 Program section between block N270 and block N200 is repeated
twice.
3 Main program REPS is executed from block N280 to block N350.
4 Program section between block N350 and block N150 is repeated
once (including the program section repeat between block N200
and block N270).
5 Main program REPS is executed from block N360 to block
N999999 (end of program).
%REPS G71 *
...
N150 G98 L1 * Beginning of program section repeat 1
...
N200 G98 L2 * Beginning of program section repeat 2
...
N270 L2.2 * The program section between this block and G98 L2
... (block N200) is repeated twice.
N350 L1.1 * The program section between this block and G98 L1
... (block N150) is repeated once.
N999999 %REPS G71 *