HEIDENHAIN TNC 410 ISO Programming - Manual (Page 366)

340 10 Programming: Q Parameters
1
0
.6 Chec
kin
g
an
d Cha
ngin
g
Q P
a
ra
met
e
rs
10.6 Checking and Changing Q
Parameters
Procedure
During a program run or test run, you can check or change Q
parameters if necessary.
U U U U If you are in a program run, interrupt it (for example, by pressing the
machine STOPP button and the INTERNAL STOP soft key). If you
are in a test run, interrupt it.
U U U U To call the Q parameter functions, press the Q key.
U U U U TNC 426, TNC 430:
Enter the Q parameter number and press the ENT
key. The TNC displays the current value of the Q
parameter in the dialog line.
U U U U TNC 410:
Using the arrow keys you can select a Q-parameter
on the current screen page. With the PAGE soft keys,
you can go to the next or the previous
screen page.
U U U U If you wish to change the value, enter a new value,
confirm it with the ENT key and conclude your entry
with the END key.
U U U U To leave the value unchanged, terminate the dialog
with the END key.