HEIDENHAIN TNC 410 ISO Programming - Manual (Page 313)

HEIDENHAIN TNC 410, TNC 426, TNC 430 287
8.8
C
y
cl
es f
o
r Mu
lt
ip
ass Millin
g 8.8 Cycles for Multipass Milling
Overview
The TNC offers three cycles for machining the following surface types:
n Created by digitizing or with a CAD/CAM system
n Flat, rectangular surfaces
n Flat, oblique-angled surfaces
n Surfaces that are inclined in any way
n
Twisted surfaces
Cycle Soft key
G60 RUN DIGITIZED DATA
For multipass milling of digitized surface data in
several infeeds
G230 MULTIPASS MILLING
For flat rectangular surfaces
G231 RULED SURFACE
For oblique, inclined or twisted surfaces