HEIDENHAIN TNC 410 ISO Programming User Manual
Page 263
HEIDENHAIN TNC 410, TNC 426, TNC 430
237
8.4 Cy
cles f
o
r Mil
ling P
o
c
k
e
ts, St
ud
s an
d Slo
ts
U
U
U
U
Set-up clearance
Q200 (incremental value): Distance
between tool tip and workpiece surface.
U
U
U
U
Depth
Q201 (incremental value): Distance between
workpiece surface and bottom of stud.
U
U
U
U
Feed rate for plunging
Q206: Traversing speed of
the tool in mm/min when moving to depth. If you are
plunge-cutting into the material, enter a low value; if
you have already cleared the stud, enter a higher feed
rate.
U
U
U
U
Plunging depth
Q202 (incremental value): Infeed per
cut. Enter a value greater than 0.
U
U
U
U
Feed rate for milling
Q207: Traversing speed of the
tool in mm/min while milling.
U
U
U
U
Workpiece surface coordinate
Q203 (absolute
value): Coordinate of the workpiece surface.
U
U
U
U
2nd set-up clearance
Q204 (incremental value):
Coordinate in the tool axis at which no collision
between tool and workpiece (clamping devices) can
occur.
U
U
U
U
Center in 1st axis
Q216 (absolute value): Center of
the stud in the reference axis of the working plane.
U
U
U
U
Center in 2nd axis
Q217 (absolute value): Center of
the stud in the minor axis of the working plane.
U
U
U
U
First side length
Q218 (incremental value): Length
of stud parallel to the reference axis of the working
plane
U
U
U
U
Second side length
Q219 (incremental value): Length
of stud parallel to the secondary axis of the working
plane
U
U
U
U
Corner radius
Q220: Radius of the stud corner.
U
U
U
U
Allowance in 1st axis
Q221 (incremental value):
Allowance for pre-positioning in the reference axis of
the working plane referenced to the length of the
stud.
Example: NC block
N35 G213 Q200=2 Q201=-20 Q206=150 Q202=5
Q207=500 Q203=+30 Q204=50 Q216=+50
Q217=+50 Q218=80 Q219=60 Q220=5
Q221=0 *