HEIDENHAIN TNC 410 ISO Programming - Manual (Page 458)

432 13 Tables and Overviews
13.1 Gener
a
l User P
a
ra
met
e
rs
Display step MP7290.0 (X axis) to MP7290.8 (9th axis, TNC 410 only to 4th axis)
0.1 mm: 0
0.05 mm: 1
0.01 mm: 2
0.005 mm: 3
0.001 mm: 4
0.0005 mm: 5 (not TNC 410)
0.0001 mm: 6 (not TNC 410)
Disable datum setting
(not TNC 410) MP7295
Do not disable datum setting: +0
Disable datum setting in the X axis: +1
Disable datum setting in the Y axis: +2
Disable datum setting in the Z axis: +4
Disable datum setting in the IVth axis: +8
Disable datum setting in the Vth axis: +16
Disable datum setting in the 6th axis: +32
Disable datum setting in the 7th axis: +64
Disable datum setting in the 8th axis: 128
Disable datum setting in the 9th axis: +256
Disable datum setting
with the orange axis
keys MP7296
Do not disable datum setting: 0
Disable datum setting with the orange axis keys: 1
Reset status display, Q
parameters and tool
data MP7300
Reset them all when a program is selected: 0
Reset them all when a program is selected and with M02, M30, END PGM: 1
Reset only status display and tool data when a program is selected: 2
Reset only status display and tool data when a program is selected and with M02, M30, END
PGM: 3
Reset status display and Q parameters when a program is selected: 4
Reset status display and Q parameters when a program is selected and with M02, M30, END
PGM: 5
Reset status display when a program is selected: 6
Reset status display when a program is selected and with M02, M30, END PGM: 7
Graphic display mode MP7310
Projection in three planes according to ISO 6433, projection method 1: +1
Projection in three planes according to ISO 6433, projection method 2: +1
Do not rotate coordinate for graphic display: +0
Rotate coordinate system for graphic display by 90°: +2
Display new BLK FORM in Cycle 7 DATUM SHIFT referenced to the old datum: +0
Display new BLK FORM in Cycle 7 DATUM SHIFT referenced to the new datum: +4
Do not show cursor position during projection in three planes: +0
Show cursor position during projection in three planes: +8
Settings for the
programming graphics
(not TNC 426, TNC 430) MP7311
Do not show penetration points as circle: +0
Show penetration points as circle: +1
Do not show meander paths in cycles: +0
Show meander paths in cycles: +2
Do not show compensated paths: +0
Show compensated paths: +4
TNC displays, TNC editor