HEIDENHAIN TNC 410 ISO Programming - Manual (Page 422)

396 12 MOD Functions
12.6
S
e
tt
ing
the D
a
ta In
te
rf
aces f
o
r T
N
C
4
26, TNC
430
Assign
This function sets the destination for the transferred data.
Applications:
n
Transferring values with Q parameter function FN15
n Transferring values with Q parameter function FN16
n Path on the TNC’s hard disk in which the digitized data are stored
The TNC mode of operation determines whether the PRINT or PRINT
TEST function is used:
You can set PRINT and PRINT TEST as follows:
File names
TNC mode of operation Transfer function
Program Run, Single Block PRINT
Program Run, Full Sequence PRINT
Test Run PRINT TEST
Function Path
Output data via RS-232 RS232:\....
Output data via RS-422 RS422:\....
Save data to the TNC’s hard disk TNC:\....
Save data in directory in which the program with
FN15/FN16 or the program with the digitizing
cycles is located - vacant -
Data Operating mode File name
Surface data Program Run Defined in the
RANGE cycle
Values with FN15 Program Run %FN15RUN.A
Values with FN15 Test Run %FN15SIM.A
Values with FN16 Program Run %FN16RUN.A
Values with FN16 Test Run %FN16SIM.A