Grass Valley Trinix Multiviewer Installation - Manual (Page 96)

TRINIX TMV Installation and Service Manual 96
Configuring, Compiling, and Publishing the TMV Configuration
2. Click the Change button. The Select Level dialog will then appear
( Figure 57 ).
Figure 57. The Select Level Dialog
Note Only valid levels for each destination will be enabled. Level mapping for des-
tinations can be seen in the Destinations list.
3. Select the preferred level. For example SDV or Audio 1-8. SDV was
selected in the example shown in
Figure 57 .
4. Click the OK button to apply the selection and close the dialog. The
destination will then be added to the list of available destinations.
Clicking the
Cancel button will close the dialog without making
changes.
Repeat these steps for up to four (4) destinations. If you select a fifth desti-
nation, it will not be added to the list.
Configuring Each Row of the Router Destination Area
The steps that are needed to configure each row of the Router Destination
area are described below. You can configure the Text, color of the fore-
ground, background, and border. The steps that are needed to configure
each row of the Router Destination area are described below.
Figure 58. The Router Destination Area- Configuring Each Row