Grass Valley Trinix Multiviewer Installation - Manual (Page 60)

TRINIX - TMV Installation and Service Manual 60
Section
3
Software Installation
Overview
This section describes the steps needed to install the Trinix Multiviewer
(TMV) software, which consists of the Trinix Multiviewer Controller, Trinix
Multiviewer Editor, and TMV firmware. The firmware is only stored on the
PC; it is installed on the TMV boards FPGAs using the NetConfig program.
Grass Valley’s NetConfig application is part of the installation application.
NetConfig may also be downloaded from the Grass Valley Web site.
Removing the TMV software is also detailed in this section. You must be
logged in as the administrator in order to remove the TMV software.
Removing the software will not remove existing user-created configuration
data.
Minimum Software Requirements
The following applications are required:
• Microsoft Windows 7 Operating System.
• Microsoft Access Database Engine
• Grass Valley NetConfig (Ver. 2.0.13)
Note The installation process will check for the Microsoft Access Database Engine
and NetConfig.
If they are present, they will not appear in the required list.
If they have not been installed previously, they will be installed as part of the
process.
Installing the TMV Software
Before you begin the installation process, make sure that the configuration
PC meets the minimum requirements. Make sure that you close all pro-
grams on the configuration PC and disable any virus protection programs
or firewalls. You should restart the computer to stop any hidden activity.