Grass Valley Trinix Multiviewer Installation - Manual (Page 32)

TRINIX TMV Installation and Service Manual 32
Figure 1. The LANS Used by the TMV Board
The Facility LAN is used to communicate with the following:
• Native Protocol (Router Control Systems)
• NetConfig
• Tally system (optional)
• TMV logging information
The Control LAN is used to communicate with the following:
• TMV Configuration Editor
• TMV Control application
1694a cables must be used. These cables should be longer than 10 M but less
than 100 M (Greater than 30 ft. but less than 300 ft.) for re-entry into the
routing switcher.
Using HDMI Converters
Grass Valley recommends that all HDMI converters that are used in a TMV
system should be 1080p (3Gb/s) compatible. The TMV board supports and
can be configured to provide the 1080p 3Gb/s video standard as an output.
HDMI converters must be 3Gb/s compatible if you are using 3 Gb/s
boards in the system. This converter is connected to a Trinix 3Gb/s
HO33300 Output board or a TMV output that has been configured for the
1080p video standard.
Input card(s)
Output card(s)
TMV board(s)
Broadlinx
Router
Control System
(Jupiter/Encore)
Control
LAN
Facility
LAN
Utility PC
Software Updates
Configuration
First Birthday
NetConfig
GUI Application
Trinix Frame
Monitor(s)
TMV Video Out
Video Sources