Grass Valley Trinix Multiviewer Installation - Manual (Page 47)

47 TRINIX — TMV Installation and Service Manual
Section 2 — Hardware Installation
TMV Rear Panel Connections
The rear panel of the Trinix Multiviewer has five different types of connec-
tors:
• Network connections
• Reference connections
• Audio connections
• Monitor connections
• Cascading connections
Each of these connections will be explained below.
Figure 4. TMV Rear Panel - Connections
Note The example in Figure 4 is for demonstration purposes; the rear panel will be
horizontal in the 128x128 frame. When it is installed in all other Trinix frames,
the rear panel will be similar to the example shown in
Figure 3 on page 46 .
Network Connections
Two Network connectors on the TMV's rear panel are labeled FAC and
CNTL. The CNTL connection is for items within the TMV network that you
want to view, monitor, or control using the TMV applications. The FAC
connection is for working with other systems within your local network;
for example, a router control system.
Follow these steps to connect the Network connections on the TMV:
1. Connect the TMV network’s CAT 5 cable to the CNTL connection. The
Following applications and messages use the CNTL LAN:
• TMV Control Application
• TMV Configuration Editor
• TMV Heartbeat Messages (system status)
Connect the
Network Con-
nections
Connect the
Reference Con-
nections
Connect the
MADI Audio
Connections
Connect the
Monitor Outs
Connections
Connect the
Cascade Con-
nections