Grass Valley Trinix Multiviewer Installation - Manual (Page 44)

TRINIX — TMV Installation and Service Manual 44
Installing the Trinix Multiviewer Board
Installing the Trinix Multiviewer Board
The following is a summary of the steps needed for installation of the Trinix
Multiviewer.
• Unpacking and Inspection
• Installing the Trinix Multiviewer Option
Unpacking and Inspection
Before unpacking the equipment, inspect the shipping carton for evidence
of freight damage. Notify the carrier and Grass Valley if the contents have
been damaged. Retain all shipping cartons and padding material for
inspection by the carrier.
Do NOT return damaged merchandise to Grass Valley until an appropriate
claim has been filed with the carrier and you have received a material
return authorization number from Grass Valley.
Installing the Trinix Multiviewer
The TMV boards are sensitive to ESD. Use static handling precautions
when installing or removing the TMV. See ESD Protection
on page 26 for
more information.
If you purchased the Trinix Multiviewer (TMV) option with a Trinix
Routing switcher, the boards will be installed at the factory. You will only
need to install the TMV boards on-site if they are to be used in an existing
routing switcher, or used as a replacement.
Installing the TMV requires that you remove the standard BNC rear panel
and Output boards, if they are present in the locations specified in
TMV
Board Location . The TMV Rear panels will then be installed in the rear of the
frame. The TMV board is installed and locked into place from the front of
the Trinix frame. Ensure that the TMV board is installed in the appropriate
slot in the Trinix routing switcher. See TMV Board Location
on page 35 . The
card slot number is important since the TMV destinations are determined
by the Routing switcher’s card slot, which is the same as a Trinix output
card.
Before starting this procedure, remove the Output boards from the front of
the routing switcher and then move to the rear of the router.