Grass Valley Trinix Multiviewer Installation - Manual (Page 123)

123 TRINIX — TMV Installation and Service Manual
Section 6 — Trinix Multiviewer Editor
Site
The properties for the Site level are Information, Default Monitor Dimen-
sions, and GMT Offset.
Information : The Name field is displayed in this section. The default name
is untitled. You cannot change the name for the configuration in this sec-
tion. You must rename it from the Rename Configurations dialog box (File>
Rename).
Default Monitor Dimensions : The pre-defined height, width, and border
bezel margin is shown. You can change the dimensions, as well as the bezel
size, of the display monitor by clicking in the preferred data entry field and
then entering a new value. The area entered should have a 16x9 aspect ratio
for the display area.
GMT Offset : You can set the number of hours and minutes that your loca-
tion is ahead or behind Greenwich Mean Time. For example, “-7:00” would
be the entry for the U.S. Mountain Time zone during Daylight Saving time.
TrinixFrame
The information for the TrinixFrame (router) is displayed. These settings
are Type, Name, System Count, Board Count, Wall Count, Monitor Count,
Tile Count, Clock Count, Text Box Count, and Audio Meter Count. Only the
Name can be changed in this section.
System
The System properties are Information, Reference, and Resources.
Information : The Information properties are Name, Board Count, Wall
Count, Monitor Count, Tile Count, Clock Count, Text Box Count, and
Audio Meter Count.
Reference : You can select the reference sync rate from the Sync Rate drop-
down list.
Resources : The Configuration theme is selected from the drop-down list in
the Resources area.
Monitor Wall
The Wall properties that are available in the Information area are Wall
Name, Active Layout Name, Layout Count, Monitor Count, Tile Count,
Clock Count, Text Box Count, and Audio Meter Count. Only the Wall
Name and Active Layout Name fields can be changed.