Grass Valley Trinix Multiviewer Installation - Manual (Page 100)

TRINIX TMV Installation and Service Manual 100
Configuring, Compiling, and Publishing the TMV Configuration
Update Destination Monitoring
The following steps assume that you have selected the Destination Monitoring
option from the Configuration Tables area.
Follow these steps to update a destination:
1. Select the destination in the Destination list.
2. You can change the level mask for the destination. You have to add a
new destination from the name drop-down list.
3. Click the Update button. The destination will change.
Discrete Audio Information
In this section, you will select the number of Discrete Audio channels per
destination for each board in a system. Each TMV board has 128 discrete
audio channels (through the two MADI inputs). If you select ten (10) chan-
nels per destination, every board in the system would have 12 destinations,
each with ten channels (128/10 =12). The remaining eight (8) channels
would not be used. Each system may have a different number of channels
per destination.
You will also select what level is mapped to the MADI channel from the
audio source.
You will need to select the number of Discrete audio channels for each
system. Then select the Level masks for the audio sources from the routing
switcher.
Follow these steps to select the Discrete audio information:
1. Select the Router Information/Configuration Tables tab if you are not there
already.
2. Click the Discrete Audio Information item in the Configuration Tables
section. The audio channels for the System will appear.
3. Select the preferred number of channels from the Discrete Audio Chs per
Dest drop-down list. In the example shown in Figure 62 on page 101 ,
“16” has been selected. Every board in the system will have four
channels per destination resulting in 32 destinations (128/4=32).
4. Configure the Level Mask used for the discrete audio destinations. The
levels are now mapped to the connections numbered 1-4 on the MADI
source.