Grass Valley Trinix Multiviewer Installation - Manual (Page 204)

TRINIX — TMV Installation and Service Manual 204
It is assumed that most customer sites will only use one tally system. If both
Image Video and TSL tally systems are used then messages from both
systems will be logged.
enableTallyLogging will turn on logging for both Image Video and TSL tally
commands. These protocols are received only from the TMV board so only
messages from the tally controller to the TMV board will be logged.
disableTallyLogging will turn off logging for both Image Video and TSL tally
commands.
enableNPSendLogging will turn on logging for Native Protocol messages
being sent from the TMV board.
disableNPSendLogging will turn off logging for Native Protocol messages
being sent from the TMV board.
enableNPRecvLogging will turn on logging for Native Protocol messages
being received on the TMV board.
disableNPRecvLogging will turn off logging for Native Protocol messages
being received on the TMV board.
Table 16. Help Debug
Command Example Definition
help TMV> help Help with logging menues.
State TMV> state Shows current station setup.
sendarp TMV> sendarp Send a gratuitous ARP.
delay TMV> delay Sets a common delay parameter.
host TMV> host Sets a common host parameter.
length TMV> length Sets a common length parameter.
setip TMV> setip Sets the interface IP address.
version TMV> version Displays the version information.
!comand TMV> !comand Pass the command to OS shell.
enableTallyLogging TMV> enableTally-
Logging Turns on logging for Tally.
disableTallyLogging TMV> disableTally-
Logging Turns off logging for Tally.
enableNPSendLogging TMV> enableNPSend-
Logging Turns on Native Protocol Send Logging
disableNPSendLogging TMV> dis-
ableNPSendLogging Turns off Native Protocol Send Logging
enableNPRecvLogging TMV> enableNPRecv-
Logging Turns on Native Protocol Receive Logging
disableNPRecvLogging TMV> disableNPRec-
vLogging Turns off Native Protocol Receive Logging