Grass Valley Trinix Multiviewer Installation - Manual (Page 200)

TRINIX — TMV Installation and Service Manual 200
Section
9
TMV Logging Commands
The following commands can be used when you are connected to the Trinix
Multiviewer board through a Telnet session.
There are many sysLog viewer that you may use to read the TMV log files.
Contact Grass Valley Tech support if you have questions or issues.
The following TMV Logging commands can be quickly accessed by
clicking on the hyperlink below:
telnetLoggingOn - Enables telnet logging
telnetLoggingOff - Disables telnet logging
stopAllTelnetLogging - Disables all telnet logging
telnetLoggingShow - Shows telnet logging metrics
setGMTOffset - Sets GMT offset
sysLoggingOn - Enables SysLog logging for a single viewer
sysLoggingOff - Disables SysLog logging for a single viewer
stopAllSysLogging - Disables all SysLog logging
sysLogLoggingShow - Shows SysLog logging metrics
verifyLogging - Sends test log messages through the system
Help Debug - Shows a list of the commands
Table 6. telnetLoggingOn
Command Example Definition
telnetLoggingOn telnetLoggingOn The telnetLoggingOn command turns on telnet logging for
this telnet session only.