Artesyn MVME2502 Installation and Use (April 2015) - Manual (Page 46)

Hardware Preparation and Installation
MVME2502 Installation and Use (6806800R96E) 46
2.5.2 PMC/XMC Support
Installation Procedure
Read all notices and follow these steps to install a PMC on the baseboard.
1. Attach an ESD strap to your wrist. Attach the other end of the strap to the chassis as a
ground. Make sure that it is securely fastened throughout the procedure.
2. Remove the PMC/XMC filler plate from the front panel cut-out.
3. Slide the front bezel of the PMC/XMC into the front panel cut-out from backside. The front
bezel of the PMC/XMC module will be placed with the board when the connectors on the
module align with the connectors on the board.
4. Align the mating connectors properly and apply minimal pressure to the PMC/XMC until it
is seated to the board.
5. Insert the four PMC/XMC mounting screws through the mounting holes on the bottom side
of the board, and then thread the four mount points on the PMC/XMC. Fasten the screws.
Damage of Circuits
 Electrostatic discharge and incorrect installation and removal can damage circuits or
shorten its life.
 Before touching the board or electronic components, make sure that you are working
in an ESD-safe environment.
Product Damage
 Inserting or removing modules with power applied may result in damage to module
components.
 Before installing or removing additional devices or modules, read the documentation
that came with the product.