Artesyn MVME2502 Installation and Use (April 2015) - Manual (Page 31)

Chapter 1
MVME2502 Installation and Use (6806800R96E) 31
Introduction
1.1 Overview
The MVME2502 is a VME form-factor single-board computer based on the Freescale QorIQ
P2020 dual core processor which features e500 cores delivering an excellent performance-to-
power ratio.The board has wide range of I/O options and is designed for applications such as
industrial control, semiconductor process equipment, radar, sonar and transportation
signaling.
The MVME2502 is designed to work in VMEbus chassis with a 3-row backplane connector
environment with a reduced I/O capacity and reduced peripheral power. It is also designed to
work in a more modern and higher performance VME chassis environment with a 5-row
backplane connector in the 2eVME or the 2eSST protocol mode.
The main features of the MVME2502 board are as follows:
 Freescale QorIQ P2020 based 6U form-factor VME board
– 1000 MHz to 1.2 GHzcore frequency
– 512 KB L2 cache
– Three 10/100/1000 Mbps enhanced three-speed Ethernet controllers (eTSECs)
– Two PCI-E 1.0a x1 interface controller
One PCI-E 1.0a x2 interface controller
– USB 2.0 interface
– Enhanced secure digital host controller
– DDR3 memory controller at 800 MT/s
– SPI interface (four chip selects, but only two are used on the board)
– Programmable interrupt controller
 Dual PMC/XMC sites
– Site1:
PMC supporting PCI-X 64/33 interface
XMC supporting PCI-E 1.0a x2 interface
– Site2:
SATA Drive Kit
 2 GB DDR3-800 soldered chip memory with ECC