Artesyn MVME2502 Installation and Use (April 2015) - Manual (Page 32)

Introduction
MVME2502 Installation and Use (6806800R96E) 32
 IEEE 1101.10 compliant or SCANBE ejector handles
 Extended Temperature /Ruggedized Option
 The front panel I/O configuration consists of two RJ45 10/100/1000BASE-T Ethernet ports,
PMC/XMC front panel I/O (optional) a USB 2.0 port, a Micro DB9 RS-232 serial console
port, and a reset/abort switch. It also has an LED to signal board failure and another LED
that can be configured in the LED register.
 The rear I/O includes support for VMEbus (Legacy VME, VME 64, VME64x, and 2eSST), rear
PMC/XMC I/O with P4 I/O, RTM I/O (through VME P2), two 10/100/1000BASE-T Ethernet,
four UART, and RTM I2C/Presence/Power.
 Persistent Data Storage: 512 KB MRAM
 User Flash: 8GB eMMC solid state storage
 Boot Flash:
– 16 MB SPI Flash (2x 8MB)
– Supports crisis recovery
 I2C Devices:
– Real-Time Clock
– Board Temperature Sensor
– 8 KB VPD EEPROM
– Two 64 KB User EEPROM
 MVME721E Rear Transition Module I/O
– Two Gigabit Ethernet interfaces
– PMC I/O from PMC1
 Operating System:
– Based from BSP provided by Freescale which is based from standard Linux version
2.6.32-rc3.
Development tool is ltib 9.1.1 (Linux Target Image Builder) from Freescale
– VxWorks
 Boot Firmware: U-Boot-based firmware image in 16 MB SPI Flash. This flash is split into two
8 MB chips.