Artesyn MVME2502 Installation and Use (April 2015) - Manual (Page 39)

Chapter 2
MVME2502 Installation and Use (6806800R96E) 39
Hardware Preparation and Installation
2.1 Overview
This chapter provides unpacking instructions, hardware preparation, installation procedures
of the board. Installation instructions for the optional PMC/XMC modules and transitions
modules are also included.
A fully implemented MVME2502 consists of the base board and the following modules:
 PCI Mezzanine Card (PMC) or PCI-E Mezzanine Card (XMC) for added versatility
 Rear transition module
 SATA kit
NOTE: MVME2502-HDMNKIT1/MVME2502-HDMNKIT2 is provided based on purchase order.
The following are the steps to be performed before using the board. Be sure to read the entire
chapter, including all caution and warning notes, before you begin.
1. Unpack the hardware. Refer to Unpacking and Inspecting the Board on page 40
2. Configure the hardware by setting jumpers on the board and the RTM. Refer to Configuring
the Board on page 43
3. Install the rear transition module in the chassis. Refer to Rear Transition Module on page 44 .
4. Install PMC module (if required). Refer to PMC/XMC Support on page 46 .
5. Install XMC span module (if required). Refer to PMC/XMC Support on page 46 .
6. If purchased, install MVME2502-HDMNKIT1/MVME2502-HDMNKIT2. Refer to Installation
of MVME2502-HDMNTKIT1/MVME2502-HDMNTKIT2 on page 48 .
7. Install the board in the chassis. Refer to Installing and Removing the Board on page 50 .
8. Attach cables and apply power. Refer to Completing the Installation on page 52 .