Artesyn MVME2502 Installation and Use (April 2015) - Manual (Page 142)

Boot System
MVME2502 Installation and Use (6806800R96E) 142
nfs Boot image through network using NFS protocol
nm Memory modify (constant address)
pci List and access PCI Configuration Space
pci_info Show information about devices on PCI bus
ping Send ICMP ECHO_REQUEST to network host
printenv Print environment variables
rarpboot Boot image through network using RARP/TFTP protocol
reset Perform RESET of the CPU
run Run commands in an environment variable
saveenv Save environment variables to persistent storage
script Run a ';' delimited, ';;' terminated list of commands
scsi SCSI sub-system
scsiboot Boot from SCSI device
setenv Set environment variables
setexpr Set environment variable as the result of eval expression
sf SPI flash sub-system
showvar Print local hushshell variables
sleep Delay execution for some time
soft_reset Soft reset the board
source Run script from memory
test Minimal test like /bin/sh
tftpboot Boot image through network using TFTP protocol
tsi148 Initialize and configure Tundra Tsi148
usb USB sub-system
usbboot Boot from USB device
version Print monitor version
Table 6-1 MVME2502 Specific U-Boot Commands (continued)
Command Description