PRG Vx76 User Manual 3.6 - Manual (Page 93)

VX76 SOFTWARE USER MANUAL 77
Intensity
The keypad can be used to adjust the brightness of the luminaire’s beam. Intensity responds to a percentage value of
0-100.
The [At] button is used to enter intensity values:
+ [n] [At] [m] [Enter] - changes the intensity level of the selected channel to m.
+ [n] [Thru] [q] [At] [m] [Enter] - changes the intensity level for the selected range of channels to m.
The [Full] button is used to quickly set intensity to 100%.
+ [n] [Full] [Enter] - changes the intensity level of the selected channel to 100%.
The [+] and [-] buttons can be used in combination with the [At] button to increment or decrement a current intensity
value by a specific amount. For example, if the current intensity value is 50%:
+ [n] [At] [+] [0] [5] [Enter] - increases the intensity level of the selected channel to 55%.
+ [n] [At] [-] [0] [5] [Enter] - decreases the intensity level of the selected channel to 45%.
To quickly enter an intensity below 91%, but divisible by 10, use only the first digit of the desired level (for
example, [At] [5] = 50%).
To Mark a channel on the command line, enter the following sequence:
+ [Chan] [n] [At] [At] [Enter]
Tip