Effect – PRG Vx76 User Manual 3.6 User Manual
Page 84
68
VX76 SOFTWARE USER MANUAL
Effect
When [Effect] is selected, the soft encoder mapping is as follows:
Fade Out (0.0)
Fade In (0.0)
Decay (0.0)
Sustain (0.0)
Attack (0.0)
Step (0.0)
Refer to the
for more information about using the encoders with effects.
Storing New Default Minimum/Maximum Settings (V476/V676 Only)
The min/max buttons associated with each function can be programmed with your own default settings as required.
These settings are referred to as hard/soft, in/out, etc. depending on the mechanism being controlled. The initial
console default settings (which correspond to the luminaire’s actual min/max values) can be re-stored with your own
min/max settings.
The min/max settings are based on channel selection. This means that a
different minimum and maximum setting can be defined for every channel
or for groups of channels as required. For example, if Channel 1 is patched
as a Bad Boy® luminaire you could select its channel and then store
appropriate min/max settings. You could then deselect Channel 1 and
select Channel 2 (which, for example is patched as a VL6C+® luminaire)
and store different min/max settings. Depending on whether Channel 1 or
Channel 2 is selected, the min/max settings would be different.
Store new min/max settings:
Step
1. Press encoder function button as required (Color, Beam, Image,
etc.). The functions will be mapped to soft encoders.
Step
2. Select luminaires to be included in min/max setting.
Step
3. Using encoders, adjust parameter for new setting.
Step
4. Press and hold [Store] while pressing [Encoder Min/Max Button].
Setting is now stored for those channels.
Add new channels to a setting:
Step
1. Select luminaires to be added to setting. (For example, select
additional VL6C+ luminaires.)
Step
2. Press and hold [Store] while pressing [Encoder Min/Max Button]. Setting is now stored for new luminaires
as well as previously stored luminaires.
Min/Max Button -
Sends default setting
to selected channels.
(User programmable.)