From keypad, Guidelines, Order – PRG Vx76 User Manual 3.6 User Manual

Page 72

VX76 SOFTWARE USER MANUAL

From Keypad

Channels may also be selected using the command-line keypad, available on the front panel.

Guidelines:

Any combinations of [ + ], [ - ], and [Thru] are
allowed.

Pressing [Enter] completes the channel selection.

Because the keypad always defaults to channel
entry mode, use of the [Chan] (channel) button is
optional.

Select a single channel:

[n] [Enter].

Select multiple channels:

[m] [+] [n] [Enter].

Select a range of channels:

[m] [Thru] [q] [Enter].

Select multiple channels including a group:

[m] [+] [Group] [n] [Enter].

Select all active channels:

[Chan] [Enter].

Other examples:

[m] [+] [s] [Thru] [w] [Enter].

m] [+ ] [s] [Thru] [w] [-] [t] [Enter].

[Clear]

[Clear] functions as a backspace key when used during command-line construction. For example, [n] [Thru]
[t] [Clear] [s] [Enter] results in the selection of channels n thru s. When [Clear] is used after an [Enter] (fully terminated
command line), the command line is cleared.

The only thing that clears a syntax error on the command line is [Clear]. Any other keypad entry is ignored until the
error condition is cleared.

Holding down [Clear] will clear an entire unterminated command line.

Note: The

order

of channel selection is retained when storing a Group. Refer to

"Ordered Groups"

on page 131.

Shift

Option

Cmd

Clear

Enter

Full

Time

Sub

Rate

Link

Thru

Loop

Force

Mark

Cue/

Delay/
Speed

Track

Back

Track/

Wait/

Trail

Sneak

Label

Move

Delete

Copy/

Sel

Park/

Patch

Undo

Recall

Store

Unpark

Update

Grab

Help

Query/

Store

Block/
UnBlk

Revert

Manual/

Effect

Set

Seq

Dynam

Group

Step

Snap

Beam

Color

Preset

Macro

Shot

Chan

Cue/

Stack

Board

Cue

ready (channel)

Tip