PRG Vx76 User Manual 3.6 - Manual (Page 127)

VX76 SOFTWARE USER MANUAL 111
To store a setting:
Step 1. Select required channels.
Step 2. Ensure the target function is selected on at least one palette (for example, Beam as shown below).
Step 3. Using manual controls, set all required parameters.
Step 4. Filter attributes as required.
Step 5. Press and hold [Store] while pressing

Palette Button

. (The store action will be confirmed by changing the
default number to white unless a label is specified.)
To apply stored settings:
Step 1. Select required channels.
Step 2. Access required function (for example, Beam as shown below).
Step 3. Access required bank by pressing and holding [Bank] button while pressing the desired Bank:

Bank 1

,

Bank 2

,

Bank 3

, etc.
Step 4. Access required page by pressing any one of five page buttons.
Step 5. Press individual

Palette Button

to apply settings. Selected luminaires will change.
For example, to apply a pre-stored Fast Rotation parameter to a luminaire, first select the channels to include. Then
locate the required palette button (59 - Fst Rot, as shown below). When this button is pressed, the settings will be
sent to the selected channels.
To store the palette and bring up the label dialog, press and hold [Store] / [Label] and

Palette Button

at the
same time.
Update Grab Store
Palette Buttons
Selected
Channels
Palette Buttons
Tip