PRG Vx76 User Manual 3.6 - Manual (Page 340)

324 VX76 SOFTWARE USER MANUAL
The coordinates are based on a point of origin (X=0, Y=0, Z=0) from which every object in your 3D graphic has been
located. By defining all three locations, you can achieve an accurate representation of your production in the Graphic
Display window.
+ X - left/right from origin.
+ Y - forward/backward from origin.
+ Z - height from origin.
Note: The Z coordinate (height) sets the top position for the luminaire’s
hook in the 3D graphic. For example, to place a luminaire on a pipe at a
height of 20
’-0" to the bottom of the pipe, the luminaire should be placed
at 20 ’-2" for accurate placement.
3D Orientation
A fixture’s 3D orientation can be entered in the Orientation section of the Patch dialog at the time the luminaire is
initially patched or any time later.
Guidelines:
+ The Patch display shows the current orientation.
+ The defaults set the orientation to common starting positions.
+ The three angular controls allow adjustment.
Point of Origin
(0,0,0)
X
Y
Z