Out time – PRG Vx76 User Manual 3.6 User Manual
Page 269
VX76 SOFTWARE USER MANUAL
253
Out Time
Out Time instructions may be stored into a cue. An Out Time will provide a "fade to no intensity level" instruction to
any luminaires that are "going
inactive
" in a cue. Out Time also provides the time value that luminaires are to fade to
inactive
in the event the submaster is deselected.
The console has a setting for a default Out Time, which is stored into all new cues where a different time is not
specified. The default setting is 3 seconds, but can be changed universally in the Settings window. Refer to
to change the default Out Time.
The [Cue/Out Time] key in the upper right of the command keypad is used to enter an Out Time:
+
The first click on the button will be Cue Time, a double-click will be Out Time.
+
If Cue Time is already entered on a command, the second press of the button will automatically show as Out
Time.
Store a cue with an out time:
+
[Store]
Add an out time to a range of cues:
+
[Cue] [m] [Thru] [n] [Cue/Out Time] [Cue/Out Time] [x] [Enter] - adds an out time of x to the range of cues m
through n.
Reset a cue’s out time back to zero:
+
[Cue] [n] [Cue/Out Time] [Cue/Out Time] [Enter].
To add an out time to the currently selected cue, press [Cue/Out Time] [Cue/Out Time] [n] [Enter] - where n is
the desired out time.
Tip