PRG Vx76 User Manual 3.6 - Manual (Page 92)

76 VX76 SOFTWARE USER MANUAL
Setting Parameters From Keypad
Presets
The keypad can be used to assign presets to selected luminaires. The preset entered on the keypad corresponds to
the preset saved in that particular Preset palette (refer to
"Presets" on page 116).
Examples:
+ [n] [Preset] [m] [Enter] - applies preset m to the selected channel n (where m is the discrete preset
number).
+ [n] [Thru] [q] [Preset] [m] [Enter] - applies preset m to the selected range of channels (where m is the
discrete preset number).
Colors
The keypad can be used to assign colors to selected luminaires. The color entered on the keypad corresponds to the
color saved in that particular Color palette (refer to
"Colors" on page 121).
Examples:
+ [n] [Color] [m] [Enter] - applies color m to the selected channel n (where m is the discrete color number).
+ [n] [Thru] [q] [Color] [m] [Enter] - applies color m to the selected range of channels (where m is the
discrete color number).
Beams
The keypad can be used to assign beams to selected luminaires. The beam entered on the keypad corresponds to
the beam state saved in that particular Beam palette (refer to
"Beams" on page 125).
Examples:
+ [n] [Beam] [m] [Enter] - applies beam state m to the selected channel n (where m is the discrete beam
number).
+ [n] [Thru] [q] [Beam] [m] [Enter] - applies beam state m to the selected range of channels (where m is the
discrete beam number).
Note: If a profile does not provide default color and beam data, then there will be no change for selected channels
until custom color and beam palettes are stored.