Sneak value or percent, Direct sneak to parameters, Sneak value or percent direct sneak to parameters – PRG Vx76 User Manual 3.6 User Manual
Page 116

100
VX76 SOFTWARE USER MANUAL
Sneak Value or Percent
Sneaks can be done by value or by percentage using either the command-line or direct-entry methods.
Using Command Line
When using the command line, the type of entry (Value or Percent) is based on the Parameter setting in the console
Settings/General window. Refer to
on page 306. In this case, enter a sneak command as usual, such as
[Sneak] [#] [Enter] - where the # is either a value or percentage based on the Parameter setting.
Using Encoder Sidebar
When using the Encoder Sidebar, press a parameter. At the numeric keypad, select either Value or Percent by
pressing the appropriate button.
Direct Sneak To Parameters
Direct sneak to parameters is possible by holding [Sneak] while pressing a parameter in the Encoder Sidebar.
Value or Percent Buttons
Numeric Keypad
Encoder Sidebar
Press and hold
[Sneak] button
while touching
parameter.
Encoder Sidebar