Recording board cues, Using record button, From keypad – PRG Vx76 User Manual 3.6 User Manual
Page 261: Using record button from keypad
VX76 SOFTWARE USER MANUAL
245
Recording Board Cues
Using Record Button
The quickest method for recording board cues, utilizes the [Board Cue Record] toggle button and command-line
keypad [Store] button. The button will flash indicating that the recording function is enabled. Pressing a second time
will disable the record function in the event you need to abort the action.
Record a board cue using record button:
Step
1. Press [Board Cue Record] toggle button. Button will flash.
Step
2. Enter sequence of playback actions as required.
Step
3. Press [Store] [Board Cue] [n] [Enter]
or
[Store] [Board Cue] [n] [Label] [Enter]
xxxxxx
Enter/Accept
-
where n is a discrete board cue number. (Board Control [Go] button will light.)
Step
4. [Board Cue Record] toggle button will stop flashing.
From Keypad
The board cue record function can be initiated from the command-line keypad. Board cue timing can also be
specified at the keypad.
When [Enter] is pressed, the [Board Cue Record] toggle button will flash indicating that the record function is enabled.
Pressing the [Board Cue Record] toggle button after this will disable the record function in the event you need to abort
the action.
Note: Command-line shortcuts can be used when storing board cues just as with standard cues. Refer to
Board Cue Record
Toggle Button