PRG Vx76 User Manual 3.6 - Manual (Page 296)

280 VX76 SOFTWARE USER MANUAL
SUBMASTER MODES
Overview
Submaster Modes
A selection of modes may be applied to each submaster using the Setup and
Control screens. These modes: Rate, Freeze, Function Filter, Channel Filter,
Dynamic Disable, Time Disable, Independent, Bump, and Manual Assign can be
used for advanced control of events during playback or to assign control of specific
channels to a submaster.
When the Function Filter (F), Channel Filter (C), Dynamic Disable (D), Timing Disable
(T), Independent (I), and Board Control Disable (B) modes are assigned, a mode
indicator will be displayed accordingly. When a Bump mode type is selected (Add/
Solo, Go Fader or Intensity Bump), it will also be displayed.
It is possible to set up all submaster modes without having the submaster selected
except Manual Assign.
Submaster Choose
The submaster "choose" function provides a method for selecting (i.e., "choosing") the submaster for the purpose of
specifying the submaster when used with various front panel key combinations. "Choose" is activated by touching
the specific submaster on the touchscreen while the other key is depressed. For example, to clear a submaster, hold
down the

Clear

key and touch the display area for that submaster on the touch screen.
When the area is touched without another key combination, the Submaster Setup options will be displayed as shown
in the screen capture below:
Mode Indicators
Bump Mode
Type
Press the area
below a
submaster’s
number to
"choose" the
submaster
Setup Options