Toshiba LF600F - Manual (Page 96)

TOSHIBA 6 F 8 A 0 8 6 9
The count rate and pulse width can be checked/changed by the following procedure.
Shown below is an example of changing the count rate from 0.0 Im^ to 0.9 1.
Key operation Display example Description
G1;
COUNT RATE
0.01000
m3
[EXT] [ENT]
Select "COUNT RATE" in the configuration item
selection screen.
The currently set count rate (0.01 m3 in this
example) is displayed.
Then press the [ENT] key.
STEP1
[ENT]
G1:
COUNT RATE
B.01000
m3
[U P] [SEL] [SET]
The switch name display at the bottom changes
(three keys [UP], [SEL] and [SET]).
At the same time, the cursor appears.
(The digit on which the cursor is positioned is
reverse-displayed.).
STEP2
[SEL]
G1:
COUNT RATE
0.01000
IBB
Move the cursor to the digit of the unit using the
[SEL] key.
[U P] [SEL] [SET]
STEP3
[UP]
[SEL]
G1:
COUNT RATE
10.0000
I
Change the unit to I using the [UP] key.
Next, move the cursor to the digit you want to
change using the [SEL] key.
[U P] [SEL] [SET]
STEP4
[UP]<^[SEL]
G1:
COUNT RATE
o.foooo
1
Change the numeric value using the [UP] key.
Repeat this operation to change the setting value to
the desired numeric value and press the [SET] key.
[U P] [SEL] [SET]
STEPS
[SET]
G1:
COUNT RATE
0.90000
/
OK? *
[NO] [SET]
When you press the [SET] key, a message con­
firming you whether the setting is OK is displayed.
If OK, press the [SET] key. If you want to redo the
setting, press the [NO] key.
STEP6-1
[NO]
G1:
COUNT RATE
B.01000
m3
Pressing the [No] key when you are asked "OK?"
causes the count rate to return to the previous value
and enables you to redo the setting.
[U P] [SEL] [SET]
STEP6-2(=END)
[SET]
G1:
COUNT RATE
0.90000
1
[EXT] fENT]
Pressing the [SET] key when you are asked "OK?"
causes the setting value to be determined.
Then press the [EXT] key. You return to the menu
screen.
Pressing the [ENT] key enables you to restart count
rate change operation from a state of 0.91.
To set the pulse width setting mode or pulse width, select the relevant item shown below.
Pulse width setting mode PLS MODE
Pulse width PLS WIDTH
Note; The unit changes as shown below by pressing [ ^ ] .
—► 1 —► ml —► bbl —►gal—► pt
in
►qt
□
-
95
-