Toshiba LF600F - Manual (Page 156)

TOSHIBA :6|F,8,A0i8|6,9|
Appendix 1
Factory default standard value table
When parameter value was appointed in order, parameter value may be different from list.
Item
Default value
(SI unit)
Default value
(Engl ish unit)
Changed value
Exciting current setting Value(*1) Value(*1)
Flow direction setting NORMAL NORMAL
Password 000 000
Address setting 126 126
Main display setting m3/h gal/min
Sub display setting m3 COUNT В
Custom (coefficient) 0 0
Custom (unit) (all blanks) (all blanks)
LCD density adjustment 3 3
Switch position setting BOTTOM BOTTOM
Range type SINGLE SINGLE
Range 1 Value(*1) Value(*1)
Range 2 to 4 0.00 m3/h 0.00 gal/min
Range hysteresis 3.0 % 3.0%
Damping constant 1.0s 5.0 s
Low cut value 1.0% 1.0%
Current output setting upon
alarm occurrence
4mA 4mA
Display low cut Yes/No OFF OFF
Output low limit setting 4mA 4mA
Digital output 1 PULSE OUT PULSE OUT
Digital output 2 (*2) NO USE EMPTY
Digital input 1(*2) C RES/STA C RES/STA
D01/D02 alarm output state(*2) NORMAL OPEN NORMAL OPEN
Dl control signal level
setting(*2)
H LEVEL H LEVEL
Count rate 1 m3 Value(*1)
Pulse width setting mode AUTO MANUAL
Pulse width 100 ms 5 ms
Preset count value 00000000 00000000
Preset output setting HOLD HOLD
High limit alarm ON/OFF OFF OFF
High limit value setting 0.0 % 0.0%
Low limit alarm ON/OFF OFF OFF
Low limit value setting 0.0 % 0.0 %
High high limit alarm ON/OFF OFF OFF
High high imit value setting 0.0% 0.0 %
Low low limit alarm ON/OFF OFF OFF
Low low limit value setting 0.0 % 0.0 %
Fluid empty alarm NORMAL NORMAL
-
155
-